FREQUENCIES Home
Wireless (pre-1920) Radios
Marconi Wireless (pre-1920) Sets
Tubes & Valves
Crystal Set Radios
Antique Radios (1920s)
Antique Radios (1930-1960s)
Antique Radio Advertising
Radio Speakers & Microphones
Articles on Antique Radio I Have Written
Radios for sale
Wanted Radios
Tubes for sale
Tube Amplifiers
Defeating Depression book by Howard Stone
Interview of Howard Stone on Tube Talk Classic Radio Show
Early Books and Literature on Radio, Tubes, & Electricity
Contact
Me
|
![](/images/84.jpg) | Marconi Wireless Radio Wavemeter | Wavemeters measure the length of waves; they determine the frequency of a transmission or help calibrate the dial of a receiver. They were one of the first pieces of test equipment developed at the beginning of radio.
In 1906 G. Marconi first introduced the Marconi Wavemeter Number One in England. The first commercial wavemeter that Marconi made, it was used mainly for ship-to-ship and ship-to-shore communication. It typically covered the frequencies of 100-800 meters (this particular wavemeter, when introduced, was calibrated to measure from 200-1040 meters).
I found the Marconi Wavemeter pictured in Illustrations 1 & 2 while living in Cambridge, England this past school year. It was a basket case. The glue was no longer holding and it was falling apart at all of the joints. The leather was dried and curled up. The leather had to be soaked to soften it and re-glued to the box on the left that holds the earphone.
Because the wavemeter was in such poor shape, I was not sure how the finish should look. It did not look like other early Marconi apparatus I had seen. I tried to find one in someone's collection in the United Kingdom--no luck. The Science Museum in London had several later Marconi wavemeters, but not the Number One. I contacted the Marconi archives in England; they replied that they had an example of this wavemeter in their collection but would not let me see it because the archives are not open to the public. Bad news for those studying or restoring early wireless. Finally, I mailed some stain chips and a list of specific questions to the archives and got some answers. I found out what I suspected--the wood of the case was TEAK. Not mahogany, oak or walnut as one might expect in radios or wireless equipment, though it makes sense for equipment used on shipboard. Fortunately, about half of the original finish was still there so the rest of the finish could be blended in.
The detector used in the wavemeter is a chunk of crystal wedged in-between two 2 inch long pieces of spring brass to the back left of the condenser. The small turned round wood box in the back of the earphone box is for spare crystals. The card in the lid is for calculating the wavelength. Surrounding the card wrapped in black tape is the coil.
For more information on the Marconi Wavemeter Number One see the attached article on it in this website.
|
|